eflite

Matek 8 Bit WS2812B RGB 5050 light LED 5v for AVR, Arduino uno r3 Naze32/CC3D

9,99 $CA
Les prix en ligne peuvent différer de ceux en magasin.

Description rapide

Item Name:WS2812B RGB 5050 LED
Voltage: about 5V
Ports: Digital
Size: 51x10 mm
Platform: AVR, Arduino,Naze32 / CC3D Flight Control (need to brush CleanFlight)

Features:
Built-in controller chip, only need an IO port to control multiple LED
Chip built-in shaping circuit,signal distortion is not cumulative, stable display
Trichromatic 256 brightness adjustment, scan frequency is not less than 400Hz / S
Serial connection-level interface, through a signal line to finish receiving and decoding data
Both ends have interfaces (DIN DOUT) that can be cascaded
Will show the flight control lock / unlock,left and right aileron, brake, throttle, alarm and other status.

Note:
If it is used for Naze32 or CC3D flight control,it need to brushed CleanFlight, and using PPM receivers.

Used for CC3D flight controller,you should pay attention to the following points:
-CC3D need to brushed CleanFlight firmware.
-Using PPM / SBUS receiver, you don’t use PWM receiver.
-GND 5V DIN behind the lights should connected to CC3D fifth row - + S of the motor output side.
-Choosing PPM receiver in the CF's assistant software configuration,then choose LED_STRIP options.
-Finally into the CF assistant software LED Strip Page to setup various states

Matek 8 Bit WS2812B RGB 5050 light LED 5v for AVR, Arduino uno r3 Naze32/CC3D

Double-cliquez sur l'image ci-dessus pour la voir en entier

Zoom arrière
Zoom avant

Plus de vues

Détails

Soyez le premier à commenter ce produit

Mots clés du produit

Utilisez un espace pour séparer les mots clés. Utilisez l'apostrophe (') pour rédiger une phrase.